PDA

View Full Version : TEC-LAUNCH hand launcher



Roughriding Woody
12-30-2005, 02:40 PM
Has anyone used one of these?? Is there a way to make one of these a remote launcher?

Mario Monico
12-30-2005, 06:40 PM
Yes if you go to lc supply they have a stand but you may want tocheck if it work with that brand .

Roughriding Woody
12-30-2005, 06:58 PM
Jerry,

Do you have a stand that will work for a TEC-Launch launcher? I have one from Chriastmas.

Roughriding Woody
12-30-2005, 07:02 PM
Sorry, wrong room.

Mike Bons
12-31-2005, 11:31 AM
Here is a picture of a remote launcher I made with one.
http://i11.photobucket.com/albums/a164/MikeBons/Winger021small.jpg
Mike

Mike Bons
01-01-2006, 11:59 AM
Here is a link to a picture simliar to the one I posted above with some details written on it. The writing is a little small but if you download it and blow it up you should be able to read it. http://i11.photobucket.com/albums/a164/MikeBons/Winger022description.jpg

In a nutshell this is how it works. I drilled a small hole in the bottom of the lanucher (the piece that you pull down, the firing pin). I tied a string to that which exits the PVC piping through a drilled hole. On the other end of the string a tied a loop, which hooks onto one of the sprockets on the servo. When the servo is powered by the electronics it turns, the loop of the string will then fall off the servo and release the firing pin.

Mike

Roughriding Woody
01-01-2006, 07:36 PM
Thanks Mike. I am very glad that you helped me and Woody out.

Joe