defective bumperboy bumpers, how common

[Brokengunz]

Default

Before you load the launcher blow into the open end of the Bumper; if pressure builds up and holds, your bumper will fire, if not the bumper is toast, mark it so you won't reload it again.

Bumper Boy had a batch of new bumpers made about three-four years ago which had internal weld problems. I bought ten and each one failed within a few firings, BB were aware of their flaw and replaced them all with new ones at no cost. However without the original sales receipt I doubt they would honour any warranty.



I found three bumperboy bumpers with the end of the tube blown out, how many other have had this happen?
i think bumperboy should replace them if they defective components due to POOR workmanship

[Brokengunz]

So far with solid bumpers the boys have been working great.
thanks for all the help here on this site

[Bumper Boy]

Hi there BrokenGunz,

I apologize but I'm not sure I understand this. Are you having an issue with your 4 year old bumpers that aren't holding up anymore? Do you have pictures you could send to our support@bumperboy.com ?

[Brokengunz]

its not easy to get a picture of the inside, far end, of the tube, im worrking on it