RetrieverTraining.Net - the RTF banner
1 - 2 of 2 Posts

·
Registered
Joined
·
267 Posts
Discussion Starter · #1 ·
I am having a problem with the servo arm not going all the way back into the right position after it is fired. So what happens is that more than one gets shot off at a time. I have to move the arm back with my finger. There are several servos on both of my 12 shooters that are doing this. Any help would be appreciated.
 

·
Registered
Joined
·
7,481 Posts
Step 1. Check the connection with the servo to wiring harness. Are the three prongs the same length? If not make sure they are by pushing one in or the other out with a pair of needle nose pliers. If not corrected go to step two.
Step 2. Replace servo. This is a pretty common sympton that the servo is bad.
 
1 - 2 of 2 Posts
Top