RetrieverTraining.Net - the RTF banner
1 - 6 of 6 Posts

Dixiedog78

· Registered
Joined
·
141 Posts
Discussion starter · #1 ·
Does anybody know what size drill bit I need to use to for Zinger Winger plungers? I have three ZW's that I just bought gromets and plungers for... they are for my TT remote releases. One of the wingers already has holes on it but they are to big for the gromets and plungers. Thanks
 
It took me a minute to figure out what you were asking. Most people I know don't use those. We use the attachments that are similiar to velco, but it isn't. You can get there from Zinger Winger or Gundogsupply. They are about six inches long and about one inch wide. You put one on the zinger and one on the TT release. They have a peel off sticky glue to attach. You then just push the release on the zinger leg. They work great. Only about $15 for a good supply of them. Hope I explained this ok.
 
They are called Zinger Winger Receiver Lok.
 
Discussion starter · #4 ·
I have the ZW "velcro" already but sometimes they still fall off so I decided to go with the plungers and gromets for a more secure hold. The problem is that the plungers and gromets from ZW do not come with installation instructions. I guess I will call ZW and ask them directly. By the way, regular velcro from Home Depot does not work to hold the recievers on the ZWer's. I tried it and it is not strong enough....
 
I have the ZW "velcro" already but sometimes they still fall off so I decided to go with the plungers and gromets for a more secure hold. The problem is that the plungers and gromets from ZW do not come with installation instructions. I guess I will call ZW and ask them directly. By the way, regular velcro from Home Depot does not work to hold the recievers on the ZWer's. I tried it and it is not strong enough....
Replace the duallock. This stuff does wear out over time and needs to be replaced. Goo Gone will take care of adhesive removal.
 
1 - 6 of 6 Posts